Tag Archives: ALC

Radio-Computer Interface

Posted on 2013-06-30 by James

So I’m back on the topic of interfacing a radio to your computer – this time with a bit of a twist. In the past, I’ve discussed methods by which you could decouple your radio from your computer (and the … Continue reading →

Posted in Project | Tagged , , , , , , , , , , , , | 2 Comments

Troubleshooting an interface

Posted on 2012-12-31 by James

After we arrived home on Saturday (29th) and unpacked everything from the trip, I set out to determine the cause of my inability to operate digital while mobile. My first suspicion was an open in the cable, so I tested … Continue reading →

Posted in General, Operating, Project | Tagged , , , , , , , , | 2 Comments

Planning & Preparation ..

Posted on 2012-12-28 by James

Well, despite my intentions, I am not able to operate /M using digital modes. On our way up to Webwood, ON. I tried to make a few PSK31 contacts while Julie drove but the radio indicated no ALC while in … Continue reading →

Posted in General, Operating | Tagged , , , , , | Leave a comment

CAT control & ALC sensing complete!

Posted on 2012-08-16 by James

I’ve finally managed to finish my Arduino CAT control project! Woo hoo! The project took longer than anticipated due to a number of reasons, one of which being the fine weather we’ve enjoyed this summer (and all the camping that … Continue reading →

Posted in Project | Tagged , , , , , | 3 Comments